LinHES Forums http://forums.linhes.org/ |
|
module eth1394 does not exist in /proc/modules http://forums.linhes.org/viewtopic.php?f=1&t=12097 |
Page 1 of 1 |
Author: | jessebs [ Tue Oct 10, 2006 5:03 pm ] |
Post subject: | module eth1394 does not exist in /proc/modules |
I just finished installing knoppmyth, and during the final configuration, I run into the error "module eth1394 does not exist in /proc/modules" I am thinking this is caused by my audigy's Firewire port which I would prefer to disable. I will not be networking over it as I have a wireless network. |
Author: | Protoss [ Tue Oct 10, 2006 5:17 pm ] |
Post subject: | |
I am getting the same problem. But I don't have a firewire port on this motherboard. |
Author: | jessebs [ Tue Oct 10, 2006 5:27 pm ] |
Post subject: | |
When I was configuring it, I set it to use wireless. When i select eth0 (wired) the install procedues correctly. |
Author: | Protoss [ Tue Oct 10, 2006 5:37 pm ] |
Post subject: | |
But how did you get it past that point? Every time I re-run the configuration, it dies after configuring the time-zone. |
Author: | jessebs [ Tue Oct 10, 2006 6:04 pm ] |
Post subject: | |
I restarted and it automatically began the config process from the beginning |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |