LinHES Forums http://forums.linhes.org/ |
|
Can't set User Password in R5D1 http://forums.linhes.org/viewtopic.php?f=1&t=12737 |
Page 1 of 1 |
Author: | Wvrent [ Sun Nov 26, 2006 9:21 pm ] |
Post subject: | Can't set User Password in R5D1 |
I'm trying to do a manual install with R5D1 with the following config. (Nforce4 mobo, 1 40gb PATA drive, 2 250GB PATA drives, 2 250GB SATA drives). The 40gb is the boot drive, and I partition it as such (intending to make an LVM of the others after install). After partitioning, I choose Configure Installation and after filling in the name options am prompted to set the password. But it won't allow me to type anything in there so I can never proceed, telling me the passwords aren't the same or empty. Any ideas? |
Author: | cecil [ Sun Nov 26, 2006 9:37 pm ] |
Post subject: | |
When you type your password in, not is displayed. Type it in, press <ENTER> and type it in again. What happens? |
Author: | Wvrent [ Sun Nov 26, 2006 10:35 pm ] |
Post subject: | Ahhhh |
I guess I was expecting some kind of local echo. Seems to be fine when I put in a password accurately both times. Thank You |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |