|Page 1 of 1|
|Author:||miker [ Sat Jan 06, 2007 6:45 am ]|
|Post subject:||sata install|
I had R5E50 installed a few weeks ago and want to put R5D1 on the drive instead. Under manual / partition off the cd I see that the three properly sized partitions are there witht he 1st one bootable.
The command Format /dev/sda1 ,2 and 3 does not work. I get an error message "command not found"
I tried Gparted live cd and I see sda1 has 1.6 gigs of used space and SDA 2 has 3 gigs of used space. I used gpart to format the partitions, booted up the hard drive alone and I see the bootloader do stuff.
How can I format the drive, leave the partitions set up the way they are and do start over?
Michigan Marijuana Dispensaries
|Author:||cecil [ Sun Jan 07, 2007 2:06 am ]|
What command are you using? Did you not read the directions in the pamphlet?
|Author:||mjl [ Sun Jan 07, 2007 1:03 pm ]|
Going backwards from E50, you may have to do a manual install to sda1 and then manually fix lilo.
|Page 1 of 1||All times are UTC - 6 hours|
|Powered by phpBB® Forum Software © phpBB Group