LinHES Forums http://forums.linhes.org/ |
|
Proper Device Settings for Dual PVR250 box. http://forums.linhes.org/viewtopic.php?f=1&t=134 |
Page 1 of 1 |
Author: | Paul Davis [ Tue Nov 18, 2003 12:17 am ] |
Post subject: | Proper Device Settings for Dual PVR250 box. |
I am not sure what to use for the video and audio device settings for my dual PVR250 box. What should I configure for /dev/video etc.? I have tried a few things but cannot get sound to work on both cards. I totally love KnoppMyth and am a huge evangelist. Thanks for all your hard work. |
Author: | cesman [ Tue Nov 18, 2003 12:42 am ] |
Post subject: | |
test_ioctl by default only addresses /dev/video0. You probably have to do:test_ioctl -y mute=0 and test_ioctl -C /dev/video1 -y mute=0. Sorry, I'm not in front of my box at the moment, so you have to double check the -C. cesman |
Author: | Paul Davis [ Tue Nov 18, 2003 3:20 pm ] |
Post subject: | test_ioctl command line parameters. |
Thanks. The syntax for working with a device other than /dev/video0 is: -d, --device=<dev> Use device <dev> instead of /dev/video0 You can see this and lots else by just typing test_ioctl |
Author: | Paul Davis [ Thu Nov 20, 2003 4:42 pm ] |
Post subject: | test_ioctl did the trick for my sound |
After lots of wailing and gnashing with /dev settings in mythtvsetup, I have found the right settings for my dual-PVR250 box as well as the key to getting sound running on both. I am using /dev/video and /dev/video1 as my capture device names in setup. The line: test_ioctl -y mute=0 did the trick for me on the sound. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |