Im trying to move a knoppmyth install to a new computer. When I boot my screen ends up "input not supported" and the caps and scroll lock are both flashing.

Also noticed that when I boot the knoppmyth cd I also get "input not supported" but it appears to boot.. I was able to get the cd to boot by using the vga=normal command..

Also I am moving from a AMD Athlon to a Celeron.. If that makes any differenece..

Thanks..

jfkjfk

you'll need to boot off the cd and change the /etc/lilo.conf file from your harddrive to vga=normal then chroot and run lilo. I know that's not very specific, but I can't remember all the commands right now, a search of the forums for chroot should find a thread about it.

No that makes sense.. BUt I think I have another problem.. This computer has an add on ide card.. So the drive has now become hde instead of hda.. will that matter?

jfkjfk

yup you will need to fix that in /etc/fstab