| LinHES Forums http://forums.linhes.org/ |
|
| Problem booting from the CD when Twinhan 1020 is in slot http://forums.linhes.org/viewtopic.php?f=1&t=1430 |
Page 1 of 1 |
| Author: | JadedMan [ Wed May 12, 2004 9:07 pm ] |
| Post subject: | Problem booting from the CD when Twinhan 1020 is in slot |
When I boot the KnoppMyth CD (R4V3) with my Twinhan 1020 DVB-S card installed, I get to "Autoconfiguring devices" and then it hangs. Removing the card solves this problem. Is it ok to install KnoppMyth without the card installed and put it in and get it working after installation? I verified the card works ok in Windows. Sorry if this is a dumb 'newbie' question 
MB: ECS K7SEM 256MB RAM 40GB HD VisionPlus 1020 DVB-S On-Board Video & Sound |
|
| Author: | cesman [ Wed May 12, 2004 9:28 pm ] |
| Post subject: | |
Yes, it is ok. |
|
| Author: | JadedMan [ Wed May 12, 2004 10:30 pm ] |
| Post subject: | |
wow - thanx for the quick reply I installed the CD and put in the 1020, but now during boot it hangs. It hangs during the init phase, before anything graphical comes up. Curiously, when it hangs, the Caps Lock & Scroll Lock lights on my keyboard flash. I have tried different keyboards and mice, but that doesn't help. Any ideas?
|
|
| Author: | red3211 [ Fri May 14, 2004 9:57 am ] |
| Post subject: | |
Are you sure that you are booting with R4V3 ? this used to be a problem on r4v2 but the new bttv drivers in r4v2 stops this hang (on my twinhan dvb-t card) If you install without the card, and then comment out the bttv driver in /etc/modules then it should load withou hanging when you reinstall the card. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|