| LinHES Forums http://forums.linhes.org/ |
|
| Manual Install Problems (howto configure installation) http://forums.linhes.org/viewtopic.php?f=1&t=1449 |
Page 1 of 1 |
| Author: | fej64 [ Fri May 14, 2004 3:04 pm ] |
| Post subject: | Manual Install Problems (howto configure installation) |
Im trying to do a manual install after my automatic installation failed 3 times. In the "official knoppmyth" installation list, im suck at #12: "Configure Installation" It says choose /dev/hda1 as the partition to put knoppmyth. Where the heck do i do this? I partitioned all the drives correctly, and then rebooted like it said i might have to. I then loaded the config file with "knoppmyth myconfig=/KNOPPIX/knoppmyth" So it boots up exactly to what happened if i just hit "enter" Very confused! please help! -jeff |
|
| Author: | cesman [ Fri May 14, 2004 3:49 pm ] |
| Post subject: | Re: Manual Install Problems (howto configure installation) |
fej64 wrote: I then loaded the config file with "knoppmyth myconfig=/KNOPPIX/knoppmyth" I don't remember this being a part of manual install... If you follow the instructions step by step you should have no problems. Sorry I don't know how to make it any simpler. How does auto install fail?
|
|
| Author: | fej64 [ Fri May 14, 2004 4:06 pm ] |
| Post subject: | Re: Manual Install Problems (howto configure installation) |
[quote="cesman"][quote="fej64" I then loaded the config file with "knoppmyth myconfig=/KNOPPIX/knoppmyth" [/quote]I don't remember this being a part of manual install... If you follow the instructions step by step you should have no problems. Sorry I don't know how to make it any simpler. How does auto install fail?[/quote] Perhaps i misunderstood. That was in reference to this installation step: "Load config Use a configuration path of /KNOPPIX/knoppmyth " i assumed i did this when the PC rebooted and came to the boot: prompt. What should I have done instead? As for the auto-install failure, here is the error message: "/usr/local/bin/KnoppMyth-auto - line 608 / 1000000 syntax error: operand expected (error token is /1000000) Any ideas? Perhaps i need to re-download or re-burn the ISO like some people suggested for other problems?? Thanks again for the help, i really appreciate the creator helping me out! -jeff |
|
| Author: | cesman [ Fri May 14, 2004 4:49 pm ] |
| Post subject: | |
Perhaps a search of the forum for "1000000"? |
|
| Author: | fej64 [ Sat May 15, 2004 9:07 am ] |
| Post subject: | FIXED! |
Aha, After searching for 1000000 i found my problem. The Jumper cable on my IDE HD was set to "Cable Select" instead of "Master" Fixed that and auto-install worked like a charm!!! Thanks again! -jeff |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|