| LinHES Forums http://forums.linhes.org/ |
|
| No boot after installation "L 40 40 40 40 40 40..." http://forums.linhes.org/viewtopic.php?f=1&t=15320 |
Page 1 of 1 |
| Author: | bamse [ Tue May 22, 2007 1:50 pm ] |
| Post subject: | No boot after installation "L 40 40 40 40 40 40..." |
Installed R5F1 (auto install) and the installation was ok, no errors during the setup process. Remove the CD and reboot and only a black screen stating "L 40 40 40 40..." where the 40 comes once every ten seconds. Nothing more happens. Any idea where to start error searching? I tried to disable all unused things in the bios without luck, also tried installed 3times. AMD 64 X2 on a MSI Nvidia motherbord. |
|
| Author: | Too Many Secrets [ Tue May 22, 2007 2:02 pm ] |
| Post subject: | |
Lilo error? Don't know if this helps. |
|
| Author: | bamse [ Tue May 22, 2007 2:08 pm ] |
| Post subject: | maybe the HD |
thx, yes maybe the harddrive - using a really old 40Gb seagate that im not sure about, but it was the only pata drive i hade avalible, anyway will try another hd tomorrow and see what happens. |
|
| Author: | bamse [ Wed May 23, 2007 9:36 am ] |
| Post subject: | New sata disk problem |
Found a 80Gb Sata drive that i installed, Bios found it correctly. Reading the Pamphlet i should select "manual install" and "Select partition and create 3 partitions using cfdisk". I do this and select my hd, but pressing next i get a "Fatal error: Bad Primary partition 1: Partition ends after end-of-disk. Press any key to exit cfdisk." Any ideas where to start my error search is welcome |
|
| Author: | Too Many Secrets [ Wed May 23, 2007 9:41 am ] |
| Post subject: | |
Auto install now works on a SATA. I installed F1 with auto. Don't know if that would help. |
|
| Author: | bamse [ Wed May 23, 2007 10:21 am ] |
| Post subject: | working...! |
Yes, it works. Thx Amazing product! I can see and record tv! went to a computer shop, bought a new computer with a AMD X2 proc, MSI bord with built in 6150 nvidia card, 1Gb mem, PVR500 card, mini atx box with 350W, samsung 22" monitor, BTC wireless keybord, everything without checking hardware first dont know anything about linux but read little about mythtv on the web burn the cd from my laptop, boot the new pc with the cd replacing faulty hd (not mythv fault) and 20min conf i can see tv fun!! now i need to see what else i can use it for. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|