LinHES Forums
http://forums.linhes.org/

Lirc with Avermedia TV98 (BT848) problem
http://forums.linhes.org/viewtopic.php?f=1&t=1607		 Page 1 of 1
Author:  DFalcon [ Tue Jun 01, 2004 10:51 pm ]
Post subject:  Lirc with Avermedia TV98 (BT848) problem
Hiya,

The auto install went great and the video portion of using this card works just fine. I have tested the ir receiving portion of the card in windows and it does work (just to confirm the hardware is working).

I read the forums and recompiled lirc as indicated.

I got that done and put this line in my /etc/modutils/lirc:
alias char-major-61 lirc_gpio

And then ran update-modules

However, when it boots I get the following in my syslog:

Jun 1 23:17:56 mythtv kernel: lirc_dev: IR Remote Control driver registered, at major 61
Jun 1 23:17:56 mythtv insmod: /lib/modules/2.4.25-chw/misc/lirc_gpio.o: init_module: Invalid request code
Jun 1 23:17:56 mythtv insmod: Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters. You may find more information in syslog or the output from dmesg
Jun 1 23:17:56 mythtv insmod: /lib/modules/2.4.25-chw/misc/lirc_gpio.o: insmod char-major-61 failed
Jun 1 23:17:56 mythtv kernel: lirc_gpio (-1): card type 0x0, id 0x0
Jun 1 23:17:56 mythtv kernel: lirc_gpio (-1): cannot detect TV card nr 0!

Couldn't find a reference to "Invalid request code" in the forums...have I compiled the lirc incorrectly?

Any suggestions as to what to try next?

Thanks,

Jim
Author:  DFalcon [ Mon Jun 07, 2004 10:00 am ]
Post subject: 
With the lack of replies - can I assume that either a) no one has any other ideas about what I am doing wrong, b) I am posting in the wrong area.

If it is a) then can anyone suggest a good/cheap pre-built IR Receiver/Transmitter (I do need both) that I can purchase to get full functionality from my MythTV box?

A suggestion on where to purchase would also be appreciated.

Altought the video/audio portion is working, if you think I would be better off getting a different capture card, I wouldn't mind hearing about that too. If I understand correctly, the PVR-250/350 cards would take a lot of the load off the CPU because they do hardware compression where I don't think my current card does.

Jim
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/