| LinHES Forums http://forums.linhes.org/ |
|
| VIA NX15000G Nano Board - Install problem http://forums.linhes.org/viewtopic.php?f=1&t=17114 |
Page 1 of 1 |
| Author: | xcalie [ Sat Oct 27, 2007 8:52 pm ] |
| Post subject: | VIA NX15000G Nano Board - Install problem |
I am making myself a PVR with a Via NX15000G Nano board, and i am using a AverMedia Volar A808 Tuner. I have decided to use Knoppmyth because it apparently has native support for this Tuner, and trying to install the faulty install scripts from avermedia.com for any other distro i havent been able to get working. But anyways, the Board i have has 1 x IDE channel and 2 x SATA Channels, for some reason the IDE channel is not channel 0, so i am having some difficulty installing Knoppmyth as it only wants to install to hda whereas mine is hdc, is there anything i can pass the installer at the boot: prompt to tell it that the hdd is hdc. Or any other way to install to hdc, i cannot put the hdd on to hda as there is no other IDE riser and dont have a sata drive and then if it was a sata drive i would have the same problem (sda instead of hda).??? ANy help would be greatly appreciated. |
|
| Author: | akulcsar [ Sun Oct 28, 2007 5:08 pm ] |
| Post subject: | |
With R5F27 (and maybe R5F1 - I don't remember exactly), auto install will install either to /dev/hda or /dev/sda (so feel free to use a SATA drive). If you need to install to /dev/hdc, do a manual install. It's only a few extra steps - the biggest of which being you'll need to partition to drive(s) yourself. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|