| LinHES Forums http://forums.linhes.org/ |
|
| Post install switch to 'tv' http://forums.linhes.org/viewtopic.php?f=1&t=175 |
Page 1 of 1 |
| Author: | shrkbait [ Tue Nov 25, 2003 2:33 pm ] |
| Post subject: | Post install switch to 'tv' |
When I installed my system, I didn't choose the 'tv' option on startup because at the time I was just connected to a monitor. Is there a list of changes to make once you are up and running to do what 'tv' mode would have done? the doc Tips and Hints says: If you have the system hooked up to a TV, then **ENSURE** that /etc/X11/XF86Config-4 contains: HorizSync "30 - 50" VertRefresh "60" and If you have your box hooked up to a TV and, when it boots, you see a message saying Press <RETURN> to see modes...... You'll need to edit your lilo.conf At the top, it should say vga=<XXX>, change it to vga=normal Don't forget to lilo -v when you are done Anything else? TV out will be on an Asus 5200 board. Is 800x600 the proper resolution for that? |
|
| Author: | cesman [ Tue Nov 25, 2003 3:07 pm ] |
| Post subject: | |
I'd stay 800x600, but I don't know what your TV supports... 800x600 should be a safe bet. cesman |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|