LinHES Forums http://forums.linhes.org/ |
|
tv_grab_de: command not found http://forums.linhes.org/viewtopic.php?f=1&t=1849 |
Page 1 of 1 |
Author: | wrk [ Sun Jun 27, 2004 1:25 pm ] |
Post subject: | tv_grab_de: command not found |
Hi there! I'm currently facing some problems with KnoppMyth R4V4. I'm trying to set up the system for telekabel in austria and get tv_grab_de: command not found and the setup programm says: MythTV was unable to retrieve channel information for your provider. Please check the terminal window for more information. Any hints? greetings, wrk |
Author: | tvboy [ Mon Jun 28, 2004 5:13 am ] |
Post subject: | |
Did you check what output was visible in the console window? (You need to switch to that from the X based setup using ALT-tab. I had to hit that several times to work) |
Author: | tanzania [ Mon Jun 28, 2004 6:16 am ] |
Post subject: | |
Create a symlink to tv_grab_de_tvtoday named tv_grab_de, run it with --configure, then go back to myth again. Other possibility would be to change tv_grab_de to tv_grab_de_tvtoday in mythconverge, but i think symlink is better choice. |
Author: | wrk [ Mon Jun 28, 2004 3:26 pm ] |
Post subject: | |
Thanks that helped. Now I've got the channel information, but I've only got 3SAT and snow on the screen. How Do I set the freqency for all channels and what can I do with channels where I don't get any EPG date for? greetings, wrk |
Author: | tanzania [ Mon Jun 28, 2004 3:53 pm ] |
Post subject: | |
use mythtv-setup or the webinterface to fill up channelinformation as follows: use eg http://www.muenchen.de/Tourismus/Kultur ... radio.html bezeichnung = deutsch freqid = Kanal E8 = K8 SE10 = S8 (Sonderkanäle) ... Did you run tv_grab_de --configure? To select the channels you wanna get grabbed? |
Author: | wrk [ Mon Jun 28, 2004 5:24 pm ] |
Post subject: | |
Yes, but for some channels available in austria there is no information on tv-today. Have you solve the jittering problem? greetings, wrk |
Author: | tvboy [ Wed Jun 30, 2004 1:25 am ] |
Post subject: | |
If you missing the right channel numbers/names, check the info from your cable TV provider for your area. (in Germany under www.kabeldeutschland.de). I found that here the channel numbers were different then what is used in Myth. I had to compare the real frequencies as defined in frequency.h (could be also frequency.c - out of memory) with what your provider names for you and use the channel names from frequency.x to enter them in the channel editor |
Author: | wrk [ Wed Jun 30, 2004 10:40 am ] |
Post subject: | |
Thanks that helped a lot. I should have entered the frequencies from the beginning, but no one told me that eg 183,25 MHz should be 183250. Thanks again |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |