| LinHES Forums http://forums.linhes.org/ |
|
| no signal to monitor http://forums.linhes.org/viewtopic.php?f=1&t=2072 |
Page 1 of 1 |
| Author: | jiffnut [ Wed Jul 28, 2004 9:30 am ] |
| Post subject: | no signal to monitor |
I am a newbie and I have - for my video card - an AIW Radeon. After I run the auto install and reboot, there is no signal sent to the monitor. I know that I need to reconfigure the driver used, but I can't remember which file and what I need to put in...Thanks for the help. ~Jiff |
|
| Author: | cesman [ Wed Jul 28, 2004 9:46 am ] |
| Post subject: | |
If you're hoping to build a MythTV boxen around the Radeon AIW, forget it. As far as I'm aware, not many people have had much success with the Radeon. Not only that, the tuner doesn't function with MythTV. |
|
| Author: | jiffnut [ Wed Jul 28, 2004 10:16 am ] |
| Post subject: | |
Well, like I said, its just my video card - and I got it for free. I'm using a PVR-250 for capture. I had RedHat 9.0 installed a while ago and I had the same troubles. I went in and edited the XFree86config? file, changing the video driver from radeon to generic I believe and this worked. Not only that, but the card's video out worked as well. I just can't remember if that was the exact name of the file and what exactly I changed... |
|
| Author: | cesman [ Wed Jul 28, 2004 10:37 am ] |
| Post subject: | |
/etc/X11/XF86Config-4 |
|
| Author: | jiffnut [ Wed Jul 28, 2004 10:54 am ] |
| Post subject: | |
Just what I needed. Thanks. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|