okay so i originally had a pvr-250 (which i had to upgrade ivtv drivers to get to work) and a wintv go which i just stuck in the system and everything worked fine. Now I have reinstalled the knoppmyth because it was having some problems before. Now here is the problem. When I run mythtv-setup and i choose the tuners, it gives me two tuner-0's. When it worked before, it gave me a tuner-0 for my pvr-250 and a television-0 for my wintv go. I had this issue for a few months (there was another reinstall between this one and the one that the tuners worked on) and just ignored it, only using one tuner and thinking that if i reinstalled again it would work...but now it still doesn't work after a reinstall and I have some time on my hands and i'm determined to fix it. I tried searching and I tried a few of the fixes to other bttv problems but they seemed to just cause more.


on the little black chip on it.

I put this in the installation because I know for a fact it was working on my previous install. Lots of other stuff was screwed up but both cards were definitly working.

Thanks
Jon

well i tried doing this
http://mysettopbox.tv/phpBB2/viewtopic.php?t=2433

but that didn't help.

When i take out the 250, the screen is all green except for a bit of grey at the top.

Jon