| LinHES Forums http://forums.linhes.org/ |
|
| AverTV DVB-T 771 and R5A10 http://forums.linhes.org/viewtopic.php?f=1&t=3608 |
Page 1 of 1 |
| Author: | moto [ Sun Feb 20, 2005 4:57 pm ] |
| Post subject: | AverTV DVB-T 771 and R5A10 |
Has anyone tried to install R5A10 and a AverTV DVB-T 771 card yet ?. Looks like the card is detected but mythtv-setup says i card find the card dvb0... any help appreciated. Is ther surposed to be a frontend0 interface like in R4V4 ? dmesg: bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 18 bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 18, latency: 32, mmio: 0xcdcfe000 bttv0: detected: AVermedia DVB-T 771 [card=123], PCI subsystem ID is 1461:0771 bttv0: using: AVerMedia AVerTV DVB-T 771 [card=123,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f0ff0f [init] bttv0: using tuner=4 tuner: Ignoring new-style parameters in presence of obsolete ones bttv0: registered device video0 bttv0: registered device vbi0 bttv0: PLL: 28636363 => 35468950 .. ok bttv0: add subdevice "dvb0" |
|
| Author: | cesman [ Sun Feb 20, 2005 6:11 pm ] |
| Post subject: | |
No firmware for DVB cards are included. If your cards requires firmware, that is the issue. |
|
| Author: | moto [ Mon Feb 21, 2005 4:06 am ] |
| Post subject: | |
Is ther a howto on installing firmware into myth for DVB-T cards ? Thankx in advance |
|
| Author: | nigelpearson [ Mon Feb 21, 2005 6:04 am ] |
| Post subject: | |
Those boot messages are mostly from BTTV, which is the Video4Linux driver. It would be for digitizing analogue video if that card has an S-Video or Composite video signal. It doesn't do much with DVB cards. Yes, there is meant to be a frontend device. I think the 771 needs the mt352 frontend, which isn't in 2.6.9 or R5A10. A quick web search found: http://www.dtvforum.info/lofiversion/in ... 14268.html which implies that 1) the Aver 771 doesn't need downloaded firmware, and 2) the kernel in R5A10, which I think is 2.6.9, doesn't include the drivers for this DVB card. 2.6.10 will probably work fine. Note that Aver has a Linux howto page: http://www.aversupport.co.uk/support/DV ... 0Linux.pdf |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|