| LinHES Forums http://forums.linhes.org/ |
|
| ivtv: Error -16 when installing http://forums.linhes.org/viewtopic.php?f=1&t=6441 |
Page 1 of 1 |
| Author: | lundqw00 [ Fri Oct 14, 2005 7:21 pm ] |
| Post subject: | ivtv: Error -16 when installing |
I had MythTV working on FC3, but due to some other installations the computer became unstable, why I decided to do a scratch install using Knoppmyth Release 5A16. At first, I successfully installed Knoppmyth all the way so I could watch TV, set-up recordings access web interface, etc. (I should have stopped here:?) However, since I have a PVR-350, I wanted to use TV-out. I therefore reinstalled Knoppmyth from scratch with "tv" specified. It worked up to reboot, but then it froze up with an ivtv error similar to the one below. Since then I have tried to reinstall it over a dozen times without TV-out to get it working again, but it keeps freezing up during the installation. The installation runs through its first “phase” OK, but after reboots it freezes with the text shown below on the screen. Any advice what to do? ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.2.0 (rc3j) loading ivtv: Linux version: 2.6.11.9-chw-2 SMP preempt 586 gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Autodetected WinTV PVR 350 card ivtv: Found an iTVC15 based chip ivtv: XXX PCI device: 0x1a30 vendor: 0x8086 ivtv: i2c attach [client=(tuner unset),ok] tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) msp34xx: ivtv version msp34xx: init: chip=MSP3448W-A2, has NICAM support, simple (D) mode, simpler (G) no-thread mode msp34xx: $Id$ compiled on: May 24 2005 00:43:28 ivtv: i2c attach [client=MSP3448W-A2,ok] saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) saa7115: detecting saa7115 client on address 0x42 saa7115: writing init values ivtv: i2c attach [client=saa7115[0],ok] saa7115: status: (1E) 0x01, (1F) 0xc0 ivtv: i2c attach [client=tveeprom,ok] tveeprom: Hauppauge: model = 48132, rev = K168, serial# = 2947714 tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3440 (type = 11) ivtv: Tuner Type 47, Tuner formats 0x00001000, Radio: yes, Model 0x00ad1598, Revision 0x00000001 ivtv: NTSC tuner detected ivtv: Radio detected saa7127: Ignoring new-style parameters in presence of obsolete ones saa7127: video encoder driver version V 0.3 loaded saa7127: detecting saa7127 client on address 0x88 saa7127: Selecting NTSC video Standard saa7127: Selecting S-Video+Composite saa7127: Turn WSS off saa7127: Widescreen Mode 4:3 Full Format saa7127: Selecting Normal Encoder Input saa7127: Enable Video Output ivtv: i2c attach [client=saa7127[0],ok] ivtv: Decoder mailbox not found ivtv: 1000 ms time out waiting for firmware ivtv: Failed api call 0x000000c4 with result 0xfffffff0 ivtv: error getting Encoder firmware version ivtv: Error -16 getting firmware version! |
|
| Author: | cazinpa [ Sun Mar 26, 2006 9:08 am ] |
| Post subject: | |
For anyone having a similar problem in the future, I had this same thing and found that trying a different PCI slot fixed it! Something to try if you are stumped. CAZ |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|