LinHES Forums http://forums.linhes.org/ |
|
mbmon/lm_sensors in R6? http://forums.linhes.org/viewtopic.php?f=11&t=19767 |
Page 1 of 1 |
Author: | nmcaullay [ Fri Apr 03, 2009 9:42 pm ] |
Post subject: | mbmon/lm_sensors in R6? |
Hi all, Has anyone had any luck with lm_sensors or mbmon in R6.. i installed lm_sensors using pacman, and ran sensor_setup (or something like that), but the results from lm_sensors is not very complete. I'm sure i got more infor on the same rig in R5.5? Thoughts? Nathan |
Author: | graysky [ Sun May 17, 2009 4:19 am ] |
Post subject: | Re: mbmon/lm_sensors in R6? |
nmcaullay wrote: Hi all,
Has anyone had any luck with lm_sensors or mbmon in R6.. i installed lm_sensors using pacman, and ran sensor_setup (or something like that), but the results from lm_sensors is not very complete. I'm sure i got more infor on the same rig in R5.5? Thoughts? Are you certain that you added the kernel modules that sensors-detect told you to add? To have them autoload on a reboot, under Arch's model (LinHES's model), you need to place them in the MODULES array in /etc/rc.conf if you want them to survive a reboot. (This sort of file under R5.5 was /etc/modules but you get the idea). Re-run sensors-detect and watch what it tells you to load. Test them via the modprobe command (# modprobe module1 then # modprobe module2 etc.) Then execute the sensors command and inspect the output. It should all be there. Once you're happy w/ that, add the needed modules to the file I mentioned above. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |