| LinHES Forums http://forums.linhes.org/ |
|
| eth0 not installed automatically?? http://forums.linhes.org/viewtopic.php?f=14&t=12577 |
Page 1 of 1 |
| Author: | soundoff [ Mon Nov 13, 2006 9:15 pm ] |
| Post subject: | eth0 not installed automatically?? |
I am trying to instal R5D1 on my newly built myth box. Backend only.. Intel D815EFV P3 1GHz 512MB Ram 320GB Seagate PATA This motherboard has onboard Intel Pro/100 LAN "LAN Subsystem Intel® 82562ET 10/100 Mbit/sec Platform LAN Connect (PLC) device" During boot i see something about eepro100 modules being loaded. I get to setup and eth0 option is there, I select it and tell it to use DHCP. It then fails every time. ifconfig only shows device lo. eth0 isnt there. When i installed R5A30.2 on my old backend eth0 just worked. Am i missing something here??? |
|
| Author: | psicard [ Tue Nov 14, 2006 1:17 pm ] |
| Post subject: | |
Have you tried running netcardconfig? |
|
| Author: | soundoff [ Tue Nov 14, 2006 10:11 pm ] |
| Post subject: | |
i thought netcardconfig jsut ran the setup program that im getting when the machine boots? I Will give it a go |
|
| Author: | soundoff [ Wed Nov 15, 2006 6:05 am ] |
| Post subject: | |
sorted! I had a network issue that was causing the DHCP request to fail. Since it was failing, eth0 was never being set up. I ran netcardconfig again, set it to a static IP, and eth0 appeared. sorted my network issue and its all good. Thanks psicard |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|