| LinHES Forums http://forums.linhes.org/ |
|
| mythbackend lost parameters - Newbie question! http://forums.linhes.org/viewtopic.php?f=14&t=15603 |
Page 1 of 1 |
| Author: | dweinberger [ Wed Jun 13, 2007 12:17 pm ] |
| Post subject: | mythbackend lost parameters - Newbie question! |
Over the past 1.5 years as I've tried and failed to install mythtv -- does that make me a permanent newbie? -- mythbackend has changed its parameters. It used to take stop, restart. and force-reload. Now it doesn't. Now -h says it takes --printexpire, --printsched, etc. Did mythbackend change? Do I have a corrupt version? Or am I missing something so obvious that I'm going to be deeply embarrassed when I find out? |
|
| Author: | slowtolearn [ Wed Jun 13, 2007 12:37 pm ] |
| Post subject: | Re: mythbackend lost parameters - Newbie question! |
dweinberger wrote: Over the past 1.5 years as I've tried and failed to install mythtv -- does that make me a permanent newbie? -- mythbackend has changed its parameters. It used to take stop, restart. and force-reload. Now it doesn't. Now -h says it takes --printexpire, --printsched, etc. Did mythbackend change? Do I have a corrupt version? Or am I missing something so obvious that I'm going to be deeply embarrassed when I find out? I don't know about previous versions, but on my KM R5D1 systems mythbackend uses the --printexpire, etc. options you refer to.
/etc/init.d/mythtv-backend, on the otherhand, accepts stop/start/restart|force-reload. |
|
| Author: | dweinberger [ Wed Jun 13, 2007 12:42 pm ] |
| Post subject: | Thanks, and here's where I say D'oh! |
D'oh! |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|