Hello all.
I'm posting, cause I can almost taste my mythtv!
I'm almost there....
I'm not sure what version of knoppmyth I have: downloaded the iso a week ago.
how do I check?
Anyways. I'll post all of my "known" configs at the end.
I have my mythtv going out my H-350 tv-out *phew*......
BUT... isn't there always a but? lol
1. my X-server is offset by a bit (bigger than my screen).
I'm using 720x480....
I tried to use xvidtune: it won't let me do any changes!
so.... what can I do to change the offset?
I don't have any sound: haven't really configured that yet.
how should I properly setup sound, via haupagge? or from sound card?
and the most important part:
I can't get any pictures: just "snow".
I have rogers cable (canada), and have setup the datadirect? for my listings, but when I change channels, no go.
I read somewhere, where I should change my tuner=2 to tuner=39???
which I have done.
is this because of the "frequencies"???
In myth tv, it gives you options to choose input:
compose1 to 4, tuner 0, and s-video.. I have it set to tuner 0. is that right?
Can anyone steer me into the right direction?
there's sooo many things that I can change in this install: based on users inputs, so I don't know where I really should start.
well, I do: and I'm now starting here...
any help would be appreciated!
Thanks,
Will
/etc/mythtv/modules/ivtv:
alias char-major-81 videodev
alias char-major-61 lirc_i2c
options ivtv debug=1
options saa7127 enable_output=1 output_select=1
# options tuner type=2 <----modified by william
options tuner type39
options msp3400 once=1 simple=1
add below ivtv msp3400 saa7115 saa7127 tuner
add above ivtv lirc_dev lirc_i2c ivtv-fb
/etc/X11/XF86Config-4:
Section "Monitor"
Identifier "NTSC Monitor"
HorizSync 30-50
VertRefresh 60
Mode "720x480"
# D: 34.563 MHz, H: 37.244 kHz, V: 73.897 Hz
DotClock 34.564
# HTimings 720 752 840 928
HTimings 700 744 832 936
# VTimings 480 484 488 504
VTimings 420 484 488 504
Flags "-HSync" "-VSync"
EndMode
EndSection
Section "Device"
Identifier "Hauppauge PVR 350 iTVC15 Framebuffer"
Driver "fbdev"
### change fb1 to whatever number you got in the previous section
Option "fbdev" "/dev/fb1"
### change the busid to whatever is reported by lspci. Note that
### output of lspci is hex, so add a preceding "0x" to the BusID
BusID "PCI:2:01:0"
EndSection
Section "Screen"
Identifier "TV Screen"
Device "Hauppauge PVR 350 iTVC15 Framebuffer"
Monitor "NTSC Monitor"
DefaultDepth 24
DefaultFbbpp 32
Subsection "Display"
Depth 24
FbBpp 32
Modes "720x480"
EndSubsection
EndSection
Section "DRI"
Mode 0666
|