| LinHES Forums http://forums.linhes.org/ |
|
| Question about the BusID in XF86Config-4 http://forums.linhes.org/viewtopic.php?f=14&t=2396 |
Page 1 of 1 |
| Author: | drjones [ Sun Sep 12, 2004 4:02 pm ] |
| Post subject: | Question about the BusID in XF86Config-4 |
Ran lspci -v results>"00:0b.0" How do I prefix that with 'a preceding "0x" to the BusID' (from the config notes) In other words - what should the final value be? Working with the 350 and most recent KnoppMyth. Using the Wiki entry - already got the 350 to output the mythtv console to the TV. Thanks. Indy |
|
| Author: | tjc [ Sun Sep 12, 2004 9:40 pm ] |
| Post subject: | |
It's the notation for a hex number. So at a guess either 0x00b0 or 0xb0 which are both the same. (176 decimal). Still a good question however, since I'm not sure what the .0 is for... Still, try one of those and see if it works... |
|
| Author: | drjones [ Mon Sep 13, 2004 11:27 pm ] |
| Post subject: | Moved card and updated BusID |
Read elsewhere about putting the 350 in the slot next to the AGP slot, so did that, restarted, ran through the setup/config prompts, and got snowy channel 57. (In Cox digital area - the channel guide comes in correct) Using the Haup remote, the screen overlay on channel change presents fine, but the actual TV picture doesn't change. Tried the output from the cable box - no picture. So ... progress, but not sure what I should be tweaking. Where are the tuner controls that people mention? Thanks! Indy |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|