LinHES Forums
http://forums.linhes.org/

Can't change channels using LinHES 8.4.3, HD PVR, QIP7100
http://forums.linhes.org/viewtopic.php?f=14&t=24688
Page 1 of 1

Author:  jfitzmyer [ Sun Oct 01, 2017 6:26 pm ]
Post subject:  Can't change channels using LinHES 8.4.3, HD PVR, QIP7100

After installation I can only watch the channel the STB is looking at. I need to find a program (script?) to change channels. I've seen references to 6200ch and mythchanger but I can't seem to find out how to get them into 8.4.3. I had this working a few years ago but I'm having trouble with newer hardware and remembering what I did before.

Would greatly appreciate any help.

Joe

Author:  tscholl [ Sun Oct 01, 2017 7:47 pm ]
Post subject:  Re: Can't change channels using LinHES 8.4.3, HD PVR, QIP710

You'll find the channel change script in the MythTV HD PVR section under installing ir Transmitter support here.
https://www.mythtv.org/wiki/Hauppauge_H ... ransmitter

Good luck.

Author:  jfitzmyer [ Sat Oct 07, 2017 6:41 pm ]
Post subject:  Re: Can't change channels using LinHES 8.4.3, HD PVR, QIP710

Thanks for the suggestion.

I was hoping to use Firewire to control my STB.

If need be I'll come back to lirc.

Thanks!

Author:  tscholl [ Sun Oct 08, 2017 12:26 pm ]
Post subject:  Re: Can't change channels using LinHES 8.4.3, HD PVR, QIP710

Did you look on the Mythtv website for FIrewire?

https://www.mythtv.org/wiki/FireWire

Or search for firewire and your stb model

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/