| LinHES Forums http://forums.linhes.org/ |
|
| default tuner channel change http://forums.linhes.org/viewtopic.php?f=14&t=7197 |
Page 1 of 1 |
| Author: | vk101 [ Sat Dec 03, 2005 3:33 pm ] |
| Post subject: | default tuner channel change |
Howdy I have IPTV (MTSTv, Winnipeg Canada). The setop box allows for 3 independent channel streams. Stream 1 is out from the set top via S-video (which I have hooked up the the amp in the living room). Streams 2 & 3 are via coax. The myth server is in the office and has a coax attached to the coax input on a Hauppauge 150. Stream 1 is 'output-ed' to channel 4 (in addition to the S-video output), stream 2 is on channel 8 and stream 3 connected to channel 11. Knoppmyth install went cleanly, but Tuner-0 defaults to channel 4 (i.e. stream 1 from the set top box). Need to change that to channel 8 (stream 2), can't quite figure it out. In mythtv-setup, for capture card settings I have it setup for MPEG-2 encoder, and Input Connection:Tuner 0:External channel change command set to 8. Also, I've changed Preset tuner to channel to 8 as well. Restart the server, and it defaults back to channel 4 (stream 1) Clear as mud? Any thoughts? |
|
| Author: | vk101 [ Sat Dec 03, 2005 4:11 pm ] |
| Post subject: | |
right well, I pulled a M$ and re-installed during the initial mythtv-setup, changed all of the values for input connection to 8, and it's all good now, for my next trick, let's see if I can set up the IR blaster ... |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|