| LinHES Forums http://forums.linhes.org/ |
|
| choppy playback http://forums.linhes.org/viewtopic.php?f=17&t=13664 |
Page 1 of 1 |
| Author: | koecks [ Sat Jan 20, 2007 1:50 pm ] |
| Post subject: | choppy playback |
Intel Celeron 2000 (downgraded to 1500 - for cooling) with 256 RAM, onboard Intel Graphics Extreme 2 graphics card. BackendMythtv - OK Seperate client with above config - live TV performs badly, like - missing frames - what do I need to configure ? I have checked DMA, which is ON. |
|
| Author: | koecks [ Sun Jan 21, 2007 9:41 am ] |
| Post subject: | driver ? |
I have a feeling that it might be the driver ? selected it is Intel Extreme Graphics 2 (comp i810) - but it sets it as VESA Xorg ? is that correct ? How can I change this ? I have tried running dpkg-reconfigure - but then MythTv won't start afterwards... even when I change it back to VESA. any ideas ? |
|
| Author: | slowtolearn [ Sun Jan 21, 2007 11:05 am ] |
| Post subject: | Re: driver ? |
koecks wrote: I have a feeling that it might be the driver ? selected You'll need to install the Intel driver. See http://support.intel.com/support/graphics/sb/CS-010512.htm. nVidia GPUs are supported "out-of-the-box", I would recommend going that route.it is Intel Extreme Graphics 2 (comp i810) - but it sets it as VESA Xorg ? is that correct ? koecks wrote: How can I change this ? I have tried running dpkg-reconfigure ... Why? What did you anticipate that would do for you?
|
|
| Author: | koecks [ Sun Jan 21, 2007 12:57 pm ] |
| Post subject: | excellent... |
I thought I could set the graphics driver with -reconfigure ? sorry if it is a stupid question, but I thought it was included ? I tried installing : http://packages.debian.org/unstable/x11 ... video-i810 but it says it is already installed - but ? perhaps that is not the driver ? |
|
| Author: | slowtolearn [ Sun Jan 21, 2007 3:51 pm ] |
| Post subject: | |
Well, if it's already installed, try setting Driver to i810 in your Xorg.conf file (I haven't seen where you mention which KM version you are using, so now I am assuming R5E50) |
|
| Author: | koecks [ Tue Jan 23, 2007 6:19 am ] |
| Post subject: | correct... |
I had actually did this... but did not work.... I needed to change the screen parameters as well, I found this : http://www.linuxquestions.org/questions ... p?t=393687 which guided me in the right direction.....excellent - now it works ! |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|