I seem to be having a problem with my nvidia settings take effect. When I watch my DVR boot up it seems that the setting are applied. The screen moves position and is adjusted horizontal and vertical for overscan. Then the settings revert to a square picture that is offset and to small.

Running nvidia-settings the Nvidia X Server Setting gui pops up and my settings take effect. Closing the nvidia settings gui the setting revert back again.

Any suggestions?
(Systems specs. in signature)

_________________
-Roseville, Michigan USA
LinHES R8: FE/BE, FE (x2)

Maybe this is in the wrong forum section?

_________________
-Roseville, Michigan USA
LinHES R8: FE/BE, FE (x2)

Hi,

I would think hardware would have been better choice for the post.

Do you have any settings from defaults with in the mythtv setup stuff? Again I have to assume that you are using a computer monitor for output display? Is your /etx/X11/xorg.conf using nvidia for the driver? Suggest checking the resolution setting also.

A slow glace over tjc's excellent Tip&Hints guide may offer some insights also.

Mike

Got it figured out. The settings were taking effect buy apparently I was not pushing them to the correct values.

Things are working now, upped the overscan, tweaked the GUI size and position and things are working like a champ.

_________________
-Roseville, Michigan USA
LinHES R8: FE/BE, FE (x2)