View unanswered posts    View active topics

All times are UTC - 6 hours





Post new topic Reply to topic  [ 2 posts ] 
Print view Previous topic   Next topic  
Author Message
Search for:
PostPosted: Sun Oct 26, 2008 1:50 pm 
Offline
Joined: Thu Jun 01, 2006 8:27 pm
Posts: 36
I have two boxes - a master and slave backend setup. In mythtv-setup on each I have the "run jobs only on original recording backend" checked. I also have "allow commercial detection jobs" checked on each.

The slave backend works as expected; it flags commercials as soon as the recording stops. The master backend queues the commercial flagging jobs, but they do not run. I can run mythcommflag by hand on the master and everything is fine. There is no relevant information in mythbackend.log

Does anyone know where I might look to get mythcommflag running automatically?

Thanks,
Hari


Top
 Profile  
 
 Post subject:
PostPosted: Sat Nov 08, 2008 5:56 am 
Offline
Joined: Thu Jun 01, 2006 8:27 pm
Posts: 36
I finally figured this out. I ran "mythjobqueue -v all" and it told me that the time was outside of the job queue window. I checked mythtv-setup and found that the job start and end times were both set to 00:00. I changed the job end time to 23:59 and now all is working again.


Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 


All times are UTC - 6 hours




Who is online

Users browsing this forum: No registered users and 27 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu