LinHES Forums http://forums.linhes.org/ |
|
Commercial flagging jobs queued but don't run http://forums.linhes.org/viewtopic.php?f=17&t=19145 |
Page 1 of 1 |
Author: | hari [ Sun Oct 26, 2008 1:50 pm ] |
Post subject: | Commercial flagging jobs queued but don't run |
I have two boxes - a master and slave backend setup. In mythtv-setup on each I have the "run jobs only on original recording backend" checked. I also have "allow commercial detection jobs" checked on each. The slave backend works as expected; it flags commercials as soon as the recording stops. The master backend queues the commercial flagging jobs, but they do not run. I can run mythcommflag by hand on the master and everything is fine. There is no relevant information in mythbackend.log Does anyone know where I might look to get mythcommflag running automatically? Thanks, Hari |
Author: | hari [ Sat Nov 08, 2008 5:56 am ] |
Post subject: | |
I finally figured this out. I ran "mythjobqueue -v all" and it told me that the time was outside of the job queue window. I checked mythtv-setup and found that the job start and end times were both set to 00:00. I changed the job end time to 23:59 and now all is working again. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |