Ok,
last year I got a DViCO HDTV DVB-T (light) I stuff around with Myth for quite a few days and could not get the system to work - then I ran out of time. This was annoying because I am a techie with a history with linux and bsd stuff.

I've just done an install and seemed to get it all working, however, when I channel scan, there is no signal on ANY channel.

I am scanning the ATSC australian channels.
I am near the transmitter so should have high available signal levels
BUT this is just with the rabit ear antennas that pick up a great picture on the analogue TV site.

I would have expected at least a low signal on some of the channels - not completely nothing.

I would really appreciate your comments. Am I being stupid with the rabbit ears, or is my card faulty (in which case its a pity I've had it a year on the shelf)

Cheers,
Mathew Frank