View unanswered posts    View active topics

All times are UTC - 6 hours





Post new topic Reply to topic  [ 2 posts ] 
Print view Previous topic   Next topic  
Author Message
Search for:
PostPosted: Sat Nov 18, 2006 10:09 am 
Offline
Joined: Sun Jul 30, 2006 9:47 pm
Posts: 5
I just reinstalled Knoppmyth to R5D1 because I wanted to upgrade my 80GB drive (250GB now). Previously everything pretty much worked out of the box.

Before I only had to run:
Code:
amixer set Master,0 100%,100% unmute
amixer set PCM,0 100%,100% unmute
amixer set Line,0 75%,75% mute captur
amixer set Capture,0 100%,100% captur
alsactl store


I did that again on the new install and I have no audio from any TV (live/recorded).

I have a MSI Hetis 865GV which uses RealTek ALC655 (ICH5 also).
My Tuner is a Compro Videomate TV Gold-Plus, video part of it works fine.

Since my last install went smooth I don't remember what modules were loaded or much of the configuration below, but this is what I have now. I think my Tuner card should be in the sound card listing (or no?).

Code:
# arecord -l

**** List of CAPTURE Hardware Devices ****
card 0: ICH5 [Intel ICH5], device 0: Intel ICH [Intel ICH5]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 0: ICH5 [Intel ICH5], device 1: Intel ICH - MIC ADC [Intel ICH5 - MIC ADC]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 0: ICH5 [Intel ICH5], device 2: Intel ICH - MIC2 ADC [Intel ICH5 - MIC2 ADC]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 0: ICH5 [Intel ICH5], device 3: Intel ICH - ADC2 [Intel ICH5 - ADC2]
  Subdevices: 1/1
  Subdevice #0: subdevice #0


That only displays my onboard sound, not my tuner card.

Code:
# lspci -v

0000:01:01.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev 10)
        Subsystem: Compro Technology, Inc. VideoMate TV
        Flags: bus master, medium devsel, latency 32, IRQ 22
        Memory at ffcee800 (32-bit, non-prefetchable) [size=2K]
        Capabilities: [40] Power Management version 2


This looks ok

I don't want digital, only analog. My cables are setup the same way I think. Line-out of tuner goes to Line-in of onboard card. Line-out of onboard card goes to speakers.

If I do
Code:
# aplay /usr/share/sounds/randomsound.wav

it works perfectly, so my soundcard should be working fine. Just not from tuner.


Code:
# amixer

Simple mixer control 'Master',0
  Capabilities: pvolume pswitch pswitch-joined
  Playback channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Mono:
  Front Left: Playback 22 [71%] [on]
  Front Right: Playback 22 [71%] [on]
Simple mixer control 'Master Mono',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined
  Playback channels: Mono
  Limits: Playback 0 - 31
  Mono: Playback 0 [0%] [off]
Simple mixer control 'PCM',0
  Capabilities: pvolume pswitch pswitch-joined
  Playback channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Mono:
  Front Left: Playback 22 [71%] [on]
  Front Right: Playback 22 [71%] [on]
Simple mixer control 'Surround',0
  Capabilities: pvolume pswitch
  Playback channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Mono:
  Front Left: Playback 0 [0%] [off]
  Front Right: Playback 0 [0%] [off]
Simple mixer control 'Surround Jack Mode',0
  Capabilities: enum
  Items: 'Shared' 'Independent'
  Item0: 'Shared'
Simple mixer control 'Center',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined
  Playback channels: Mono
  Limits: Playback 0 - 31
  Mono: Playback 0 [0%] [off]
Simple mixer control 'LFE',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined
  Playback channels: Mono
  Limits: Playback 0 - 31
  Mono: Playback 0 [0%] [off]
Simple mixer control 'Line',0
  Capabilities: pvolume pswitch pswitch-joined cswitch cswitch-exclusive
  Capture exclusive group: 0
  Playback channels: Front Left - Front Right
  Capture channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Front Left: Playback 23 [74%] [off] Capture [on]
  Front Right: Playback 23 [74%] [off] Capture [on]
Simple mixer control 'CD',0
  Capabilities: pvolume pswitch pswitch-joined cswitch cswitch-exclusive
  Capture exclusive group: 0
  Playback channels: Front Left - Front Right
  Capture channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Front Left: Playback 0 [0%] [off] Capture [off]
  Front Right: Playback 0 [0%] [off] Capture [off]
Simple mixer control 'Mic',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined cswitch cswitch-exclusive
  Capture exclusive group: 0
  Playback channels: Mono
  Capture channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Mono: Playback 0 [0%] [off]
  Front Left: Capture [off]
  Front Right: Capture [off]
Simple mixer control 'Mic Boost (+20dB)',0
  Capabilities: pswitch pswitch-joined
  Playback channels: Mono
  Mono: Playback [off]
Simple mixer control 'Mic Select',0
  Capabilities: enum
  Items: 'Mic1' 'Mic2'
  Item0: 'Mic1'
Simple mixer control 'Video',0
  Capabilities: cswitch cswitch-exclusive
  Capture exclusive group: 0
  Capture channels: Front Left - Front Right
  Front Left: Capture [off]
  Front Right: Capture [off]
Simple mixer control 'Phone',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined cswitch cswitch-exclusive
  Capture exclusive group: 0
  Playback channels: Mono
  Capture channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Mono: Playback 0 [0%] [off]
  Front Left: Capture [off]
  Front Right: Capture [off]
Simple mixer control 'IEC958',0
  Capabilities: pswitch pswitch-joined cswitch cswitch-joined
  Playback channels: Mono
  Capture channels: Mono
  Mono: Playback [off] Capture [off]
Simple mixer control 'IEC958 Playback AC97-SPSA',0
  Capabilities: volume volume-joined
  Playback channels: Mono
  Capture channels: Mono
  Limits: 0 - 3
  Mono: 0 [0%]
Simple mixer control 'IEC958 Playback Source',0
  Capabilities: enum
  Items: 'PCM' 'Analog In' 'IEC958 In'
  Item0: 'PCM'
Simple mixer control 'PC Speaker',0
  Capabilities: pvolume pvolume-joined pswitch pswitch-joined
  Playback channels: Mono
  Limits: Playback 0 - 15
  Mono: Playback 0 [0%] [off]
Simple mixer control 'Aux',0
  Capabilities: pvolume pswitch pswitch-joined cswitch cswitch-exclusive
  Capture exclusive group: 0
  Playback channels: Front Left - Front Right
  Capture channels: Front Left - Front Right
  Limits: Playback 0 - 31
  Front Left: Playback 0 [0%] [off] Capture [off]
  Front Right: Playback 0 [0%] [off] Capture [off]
Simple mixer control 'Mono Output Select',0
  Capabilities: enum
  Items: 'Mix' 'Mic'
  Item0: 'Mix'
Simple mixer control 'Capture',0
  Capabilities: cvolume cswitch cswitch-joined
  Capture channels: Front Left - Front Right
  Limits: Capture 0 - 15
  Front Left: Capture 0 [0%] [off]
  Front Right: Capture 0 [0%] [off]
Simple mixer control 'Mix',0
  Capabilities: cswitch cswitch-exclusive
  Capture exclusive group: 0
  Capture channels: Front Left - Front Right
  Front Left: Capture [off]
  Front Right: Capture [off]
Simple mixer control 'Mix Mono',0
  Capabilities: cswitch cswitch-exclusive
  Capture exclusive group: 0
  Capture channels: Front Left - Front Right
  Front Left: Capture [off]
  Front Right: Capture [off]
Simple mixer control 'Channel Mode',0
  Capabilities: enum
  Items: '2ch' '4ch' '6ch'
  Item0: '2ch'
Simple mixer control 'Duplicate Front',0
  Capabilities: pswitch pswitch-joined
  Playback channels: Mono
  Mono: Playback [off]
Simple mixer control 'External Amplifier',0
  Capabilities: pswitch pswitch-joined
  Playback channels: Mono
  Mono: Playback [off]


I heard that with the new release of Knoppmyth you need to turn off digital to hear analog, atleast on this chipset. I don't see any sign of digital in alsamixer, but I did play around and turn things off, to no avail.

Also Knoppmyth itself is setup by default. Sound going to /dev/dsp. I changed it to /dev/dsp0 and that didn't help.


Has anyone run into this or can tell me what to troubleshoot?

Thanks!


Top
 Profile  
 
 Post subject:
PostPosted: Sun Nov 19, 2006 10:38 am 
Offline
Joined: Sun Jul 30, 2006 9:47 pm
Posts: 5
A little bit more info.

If I plug my speakers directly into the Audio out of my tuner card it doesn't have any sound. Typically I would do that for testing and the sound would be off by 2-3 seconds. This time nothing is being outputted.

So it has to lie with my tuner card. What steps should I go through to see that it is setup properly?


Top
 Profile  
 

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 


All times are UTC - 6 hours




Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group

Theme Created By ceyhansuyu