All right, first off I'm a total and complete newbie, so bear with me. I apologize in advance if this has been posted before and I missed it, I searched, and found only bits and pieces that I couldn't quite work out.
Anyway, on with the question.
I just recently installed R5E50 onto my comp, which I had both my TV and a LCD hooked up to at the time and everything seemed to install fine. Only problem was when it finally loaded the GUI, it fired up just fine onto the LCD and the TV well, lets just say all the colors are there, it just makes a pretty abstract art rather than actual usefulness. The TV and LCD are both hooked through the 9800XT, S-Video out and VGA out respectively. Every time I've tried to change a setting it hasn't worked. Usually makes things worse only because I don't quite know what I'm doing. Also tried booting up with just the TV hooked up, but also to no avail.
I would greatly appreciate any help in the matter (especially as far as exact commands needed). If you need any more info please tell me and I'll see what I can dredge up.
Thanks in advance
