Solution in the Last Post - I have been working on a couple of other issues, and have rebuilt my system a couple of times now.

I am now back to the working configuration I had before I started yesterday morning.

Everything works on the system as it did before I started except now I can't get lirc to work.

This is a PVR -150 with the included Remote and Blaster.
It was all working yesterday morning.

Anyway here is what I am seeing in syslog
During Startup:

Then farther down the log I see:


This is in my syslog from one of my SBE's that is working:




So I can see where the problem is starting and showing up in that first section with this line

I can't figure out what I may have done wrong. Thoughts on where I might look.

I need to get this resolved soon for the WAF to work..

TIA
[/code]

Update:
Still no workie but here is what I tried now.

Since it seems to reside around the Capture Card and the IR Blaster attached to that.

I went back to the Hints and Tips and started at the point as if I had just rebuilt.

I killed all of my capture cards, then I shut all the boxes off.
I pulled power to them and went to do some other work for a couple of hours.

I returned, brought it back up and then installed the Cards in Mythtv-setup per the instructions.

I powered them down for a 5 minutes then brought everything back up.
Still same results as above.

I looked back in the syslog and it is telling me even before I added the cards it could not find the lirc device.

Anyway, I am still digging on this. I'll keep all informed.

TIA

FWIW Hardware in the Sigs below.

_________________
KnoppMyth R5.5
MBE: AMD64 3400+, K8N Neo4 Plat., 1Gig, Asus Extreme N6200, 320G pata, 2x320Gsata, 750Gsata, PVR-150 Retail w/Blaster
SBE: AMD XP2000, GA 7ZMMH, 1 Gig, XFX 256M 6200, 20 Gig, PVR-150 Retail w/Blaster
SBE: AMD Dur1800, 512M, PVR500

Solved!

I will have to go back and see if I can recreate the issue, but essentially it appeared to be a Bios setting.
I went back in and backed out all of the Bios settings I had made yesterday while trying to resolve the wild system time issue.

One of those seemed to have caused it to no longer recognize the lirc device.

I'll dig a little deeper and figure out which one as soon as I get through a recording cycle for one of my wood working shows.

Update, I plugged in my APC UPS cable into a USB port. when I cycled Power on the system the LIRC drivers goes back to the problem above.

I removed ths UPS cable from the MBE and cycled power on the MBE. It came back up and Lirc is responding fine.

So that appears to be the issue, now I will need to work on fixing that issue. Gonna be at least a week though.