| LinHES Forums http://forums.linhes.org/ |
|
| change from 10/100 eth to 10/100/1000 eth? http://forums.linhes.org/viewtopic.php?f=2&t=16738 |
Page 1 of 1 |
| Author: | elephant [ Wed Sep 26, 2007 3:56 pm ] |
| Post subject: | change from 10/100 eth to 10/100/1000 eth? |
I would like to add a gigabit ethernet card to my existing installation that has a working 10/100 connection now. If I shut down, install the new card, reboot, will it look for new hardware and install drivers? Thanks for any help Dave |
|
| Author: | mjl [ Wed Sep 26, 2007 4:17 pm ] |
| Post subject: | |
Hi, You will need, as root, to run netcardconfig --force to set it up. Mike |
|
| Author: | tjc [ Wed Sep 26, 2007 10:50 pm ] |
| Post subject: | |
Search for "jumbo frames" should turn up a couple discussions I was involved in about enabling this to maximize your throughput. |
|
| Author: | graysky [ Thu Sep 27, 2007 12:35 am ] |
| Post subject: | |
I agree with tjc, if your switch and NICs support it, 4k or 9k jumbo frames may boost your throughput beyond the gigalan upgrade. (Here is that thread tjc was referring to in his post.) Also, there is an article floating around out there stating that unless your uplink to your cable modem is the standard 1500 byte MTU size, (i.e. not using jumbo frames) your internet connectivity will be mess-up. This is simply not true in my experience. All the systems behind my switch use 4k jumbo frames. The switch talks to my router (which doesn't support jumbo frames) and the router to my cable modem all without any issues. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|