| LinHES Forums http://forums.linhes.org/ |
|
| Hauppauge WinTV PVR 150 http://forums.linhes.org/viewtopic.php?f=2&t=18080 |
Page 1 of 1 |
| Author: | gorcsos [ Sat Mar 22, 2008 7:20 pm ] |
| Post subject: | Hauppauge WinTV PVR 150 |
I have just bought a Hauppauge WinTV PVR 150 MCE and I have a hard time to set it up even if I just have used the remote control files by rusty0101. I have read that the basic config is of r the gray remote, but I have done already some changes. How could I recall the program what sets up the remote control configuration? It comes up in a terminal window during the basic configuration. Any suggestions? It would be great if I could use my USB blue-tooth mouse instead of remote. Is it possible to set it up and how? Thank you! Gabor http://www.bestbuy.ca/catalog/proddetai ... atid=20397 It shows a gray remote on the box but in reality its black. |
|
| Author: | gorcsos [ Sat Mar 22, 2008 8:35 pm ] |
| Post subject: | recording the ir remote codes... |
I believe that the solution is to record the ir remote codes. I just have tried to stop it (lircd stop), but something keeps to restart it or what, irrecord replies that lircd still runs or some there is some permission problem. Any idea how to stop a process and turn off this auto restart? Gabor For those interested in doing this, you have to go through the following steps: Stop lircd (/etc/init.d/lircd stop, take note of the pid for the process, and kill it) start recording using irrecord (irrecord filename [I used irrecord hauppauge.black]) Follow the instructions, Don't do anything too early, or you will probably have to start all over again. When irrecord completes, review the output file. (it will be filename.conf, or in my case hauppauge.black.conf) Confirm that you don't have duplicate button presses (I found that vol- had the same code as Radio, which was the button I had pressed previously. It also had an escaped character ahead of the name) If you run into numerous problems in the file, record again, otherwise copy this file over /etc/lircd.conf restart lircd, (/etc/init.d/lircd start) test the results with irw Here is the file I ended up creating, on the off chance someone would like to make use of it. |
|
| Author: | slowtolearn [ Sun Mar 23, 2008 8:31 am ] |
| Post subject: | |
See http://knoppmyth.net/phpBB2/viewtopic.php?t=426 Multiple posts in mutliple forums asking the same question isn't likely to solicit more/better answers... |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|