LinHES Forums http://forums.linhes.org/ |
|
like to setup lirc +streamzap on an Arch box http://forums.linhes.org/viewtopic.php?f=21&t=20591 |
Page 1 of 1 |
Author: | graysky [ Thu Nov 26, 2009 8:17 am ] |
Post subject: | like to setup lirc +streamzap on an Arch box |
I'm running Arch Linux i686 which uses lirc v0.8.6 with a streamzap usb remote. I can't get the remote to function 100 % of the time. 1) I installed both the lirc and lirc-utils packages 2) I copied over the lircd.conf for my remote from /usr/share/lirc/remotes/streamzap/lircd.conf.streamzap 3) I modprobed both modules listed on this page 4) I started lircd. I'm using the standard streamzap usb remote/receiver. When I test it with irw, it works for a little while, but then lircd seems to ignore the remote commands completely. I hit buttons, but nothing gets registered by irw. Code: # cp /usr/share/lirc/remotes/streamzap/lircd.conf.streamzap /etc/lirc/lircd.conf # modprobe lirc_dev # modprobe lirc_streamzap # /etc/rc.d/lircd start :: Starting LIRC Daemon $ irw 00000000000028cc 00 CH_UP Streamzap_PC_Remote 00000000000028ce 00 CH_DOWN Streamzap_PC_Remote 00000000000028c8 00 8 Streamzap_PC_Remote 00000000000028c5 00 5 Streamzap_PC_Remote 00000000000028d2 00 OK Streamzap_PC_Remote 00000000000028d1 00 LEFT Streamzap_PC_Remote 00000000000028d1 01 LEFT Streamzap_PC_Remote 00000000000028d1 00 LEFT Streamzap_PC_Remote 00000000000028d3 00 RIGHT Streamzap_PC_Remote 00000000000028d3 00 RIGHT Streamzap_PC_Remote 00000000000028d3 00 RIGHT Streamzap_PC_Remote 00000000000028d3 00 RIGHT Streamzap_PC_Remote 00000000000028d4 00 DOWN Streamzap_PC_Remote 00000000000028d4 00 DOWN Streamzap_PC_Remote 00000000000028d4 00 DOWN Streamzap_PC_Remote <<<At this poiint, lircd just ignores the buttons>>> All I get in my /var/log/lircd is: Code: Nov 27 05:25:37 lightning lircd: caught signal Nov 27 05:25:40 lightning lircd: lircd(default) ready, using /var/run/lirc/lircd Nov 27 05:25:43 lightning lircd: accepted new client on /var/run/lirc/lircd Nov 27 05:26:04 lightning lircd: removed client Suggestions are appreciated. /etc/lirc/lircd.conf Code: #
# this config file was automatically generated # using lirc-0.7.1-CVS(serial) on Fri Feb 4 23:20:56 2005 # # contributed by Christoph Bartelmus # # brand: Streamzap # model no. of remote control: PC Remote # devices being controlled by this remote: USB receiver # begin remote name Streamzap_PC_Remote bits 6 flags RC5|CONST_LENGTH eps 30 aeps 100 one 889 889 zero 889 889 plead 889 pre_data_bits 8 pre_data 0xA3 gap 108344 toggle_bit 2 begin codes 0 0x00 1 0x01 2 0x02 3 0x03 4 0x04 5 0x05 6 0x06 7 0x07 8 0x08 9 0x09 POWER 0x0A MUTE 0x0B CH_UP 0x0C VOL_UP 0x0D CH_DOWN 0x0E VOL_DOWN 0x0F UP 0x10 LEFT 0x11 OK 0x12 RIGHT 0x13 DOWN 0x14 MENU 0x15 EXIT 0x16 PLAY 0x17 PAUSE 0x18 STOP 0x19 |<< 0x1A >>| 0x1B RECORD 0x1C << 0x1D >> 0x1E RED 0x20 GREEN 0x21 YELLOW 0x22 BLUE 0x23 end codes end remote |
Author: | manicmike [ Thu Nov 26, 2009 4:07 pm ] |
Post subject: | Re: like to setup lirc +streamzap on an Arch box |
I thought lirc looked in ~/.lircrc for its frontend config file. Maybe your system is different? Mike |
Author: | graysky [ Fri Nov 27, 2009 8:40 am ] |
Post subject: | |
Found the problem: low batteries in the remote! Unbelievable! |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |