LinHES Forums http://forums.linhes.org/ |
|
Proper use of xconfig.sh? http://forums.linhes.org/viewtopic.php?f=21&t=24184 |
Page 1 of 1 |
Author: | Liv2Cod [ Wed Jun 10, 2015 12:59 pm ] |
Post subject: | Proper use of xconfig.sh? |
I'm trying to get my video working since I have the same problem as "squashfs errors" with my system (onboard nVidia 8200 graphics). But when I run the command xconfig.sh all I get is: Using User Supplied X Didn't find the file Plus, it places a file in the /etc/X11 directory that says: Copy your config file to /home/mythtv/templates/xorg.user Of course, X tries to interpret this file as a "real" xorg.conf file and fails to initialize X at all. I'm sure there's a simple fix for this, but I have no idea where to look. -- Joe |
Author: | brfransen [ Wed Jun 10, 2015 5:21 pm ] |
Post subject: | Re: Proper use of xconfig.sh? |
Sounds like User Supplied Config got checked in the LinHES Display Settings. In /etc/systemconfig change XIgnoreConfig="0" then run xconfig.sh again. Once X starts again go into the LinHES Settings Display and make sure User Supplied Configuration is not checked. |
Author: | Liv2Cod [ Sat Jun 13, 2015 10:23 pm ] |
Post subject: | Re: Proper use of xconfig.sh? |
You are correct sir. When I restored the backup, it also restored that change to my system. I modified the /etc/systemconfig and the LinHES setting as you suggest and it was just what I needed. I've since discarded that motherboard for other reasons and I'm trying to get Intel graphics working on my new platform. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |