LinHES Forums
http://forums.linhes.org/

How to re-configure back end?
http://forums.linhes.org/viewtopic.php?f=22&t=23663
Page 1 of 1

Author:  drjenk [ Sat Dec 29, 2012 7:34 am ]
Post subject:  How to re-configure back end?

I know this sounds simple, but I've just done a fresh install, coming from mythbuntu for the past couple years. I used to launch the mythbackend configuration via the mythbuntu control center. Upon initial boot of LinHES, it did prompt me for backend settings, but I accidentally hit esc before done, and now I can't get back. When I back out the desktop, it's completely empty, and I see no menu item for "backend configuration", nor do I see any in the frontend menus. I know the answer will be simple but I am just not seeing it. Thanks

Author:  jams [ Sat Dec 29, 2012 9:07 am ]
Post subject:  Re: How to re-configure back end?

either press ctrl+s when the desktop is displayed, or open a terminal and run mythtv-setup.

Author:  mattbatt [ Sat Dec 29, 2012 10:49 pm ]
Post subject:  Re: How to re-configure back end?

"alt s" =setup
"alt m" starts MythTV if you are in the desktop for some reason.
"alt 1" starts backend
"alt 2" stops backend
"alt 3" restarts backend
"Ctrl alt u" Un-hides the mouse outside of the MythTV window.
I can't remember the rest.

Author:  christ [ Sun Dec 30, 2012 10:38 am ]
Post subject:  Re: How to re-configure back end?

mattbatt wrote:
I can't remember the rest.

Alt h --- gives you the list! :D

Author:  drjenk [ Thu Jan 03, 2013 10:50 pm ]
Post subject:  Re: How to re-configure back end?

thanks all, got the hang of it now. Installed on front end, upside down video, parallel post....

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/