LinHES Forums http://forums.linhes.org/ |
|
Help Installing 8.3 from SD card http://forums.linhes.org/viewtopic.php?f=22&t=24225 |
Page 1 of 1 |
Author: | Greg Frost [ Tue Aug 18, 2015 1:51 am ] |
Post subject: | Help Installing 8.3 from SD card |
I attempted to install Release 8.3 from an SD card. I created a bootable SD card using unetbootin. This method works fine with R7.4. The boot starts but fails early on. Here is an image of what I see when the boot fails: |
Author: | Greg Frost [ Tue Aug 18, 2015 4:45 am ] |
Post subject: | Re: Help Installing 8.3 from SD card |
Nevermind about that problem. I found that if I created the SD card using the command: Code: dd if=LinHES_R8.3.iso of=/dev/sdc (where /dev/sdc is the SD card device) Then I got a bit further. But now I'm stuck at this point: It just sits there at 3% with the error shown at the bottom. I did this again using all default install options other than the timezone and the hostname and it stopped at the same point. Any ideas? [edit] another observation: the /tmp/mythvantage_install.log shows transferring system, and then the standard_in error is repeated every couple of seconds. If I leave it sitting there, top shows all of the memory being consumed and then the box locks up and becomes unresponsive. |
Author: | Greg Frost [ Fri Aug 21, 2015 6:02 pm ] |
Post subject: | Re: Help Installing 8.3 from SD card |
The HDD in the target machine was stuffed. I'm not sure why it resulted in those symptoms, but I was able to install after replacing the HDD. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |