LinHES Forums http://forums.linhes.org/ |
|
Debugging R8.3 Install on Frontend http://forums.linhes.org/viewtopic.php?f=22&t=24231 |
Page 1 of 1 |
Author: | kmkittre [ Thu Sep 10, 2015 7:49 am ] |
Post subject: | Debugging R8.3 Install on Frontend |
I'm in the process of upgrading from R7 to R8.3. My backend upgrade went mostly fine (I have questions, but those can wait until I have a working system...). However, my standalone frontend installation didn't go as well. I get to the LinHES boot screen with the dots moving across the bottom, but it never gets past there. I'm guessing there's a problem with the video driver? Is there a way to temporarily disable this splash screen so that I can see where it's getting hung? Or, am I better off checking the logs? I'm assuming everything is still in /var/log? |
Author: | brfransen [ Thu Sep 10, 2015 10:58 am ] |
Post subject: | Re: Debugging R8.3 Install on Frontend |
F1 should remove the splash. |
Author: | kmkittre [ Thu Sep 10, 2015 1:40 pm ] |
Post subject: | Re: Debugging R8.3 Install on Frontend |
Thanks! I'll report back so that my solution is documented. |
Author: | kmkittre [ Mon Sep 14, 2015 12:13 pm ] |
Post subject: | Re: Debugging R8.3 Install on Frontend |
So, the error was that my swap was missing in fstab. I finally pinned the source problem to me messing with partition sizes during install. If I left them alone, everything worked fine. My best guess is that LinHES ran out of disk space during the install. I don't see how that resulted in a "successful" install. Perhaps some additional error checking is needed. Anyway, problem resolved, thanks for the assistance. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |