LinHES Forums
http://forums.linhes.org/

add custom lirccd.conf for Cisco RNG100
http://forums.linhes.org/viewtopic.php?f=24&t=21869
Page 1 of 1

Author:  George [ Sun Oct 31, 2010 8:26 am ]
Post subject:  add custom lirccd.conf for Cisco RNG100

I have a 6.03 install using a PVR250 on analog Comcast

Previously I had a 5.x install and was using a serial irblaster I made to control a DISH box.

Comcast is converting our area to digital so I have a new Cisco RNG-100 box.

Since 6.0x has a config system built in for an irblaster it would seem the way to do this would be to get the proper lirc config file for the RNG-100 and create a new directory in templates such as /usr/MythVantage/templates/transmit/rng_100 and copy the new lircd.conf there and then use the setup to link the serial port to that config?

I found someone had mentioned they needed to control a RNG100 on a 5.x install and they used this config file:

http://lirc.sourceforge.net/remotes/com ... m-3-Device

Author:  cesman [ Sun Oct 31, 2010 11:12 am ]
Post subject: 

Yes, creating a dir and copying your config to it would make it available thru the Service Menu. Should the lircd.conf work for you, please open a ticket so we can include it in future releases.

Author:  George [ Sun Oct 31, 2010 4:42 pm ]
Post subject: 

Thanks,

I will post what results I get and open a ticket if it works.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/