LinHES Forums http://forums.linhes.org/ |
|
xine won't play dvds after upgrade. http://forums.linhes.org/viewtopic.php?f=5&t=15360 |
Page 1 of 1 |
Author: | mjl [ Thu May 24, 2007 10:18 pm ] |
Post subject: | xine won't play dvds after upgrade. |
Hi, Have not seen anyone else mentioning this however, I have not been able to get the "home brewed" dvd or a dvd iso to play. Was hard to catch however it throws up an error message about keybindings being the same for all keys... So what I see is the intro plays and then waits for a keypress that you can't give it. Mike |
Author: | tjc [ Fri May 25, 2007 6:07 pm ] |
Post subject: | |
Easiest cure is probably to knock out the /home/mythtv/.xine configuration and then run xine from a command line where you've got a keyboard and a mouse. This should let you set up the configuration. The file you want to tweak after that is "/home/mythtv/.xine/keymap". My xine complains momentarily about some overlapping keybindings when you exit, but other than that it works just fine. |
Author: | mjl [ Sat May 26, 2007 7:28 pm ] |
Post subject: | |
Thanks tjc, But it didn't work ![]() Internal player don't play dvds either. Looks like I am going have dig a little deeper.. Did notice gbs.tv does not play either but only tested on one upgraded box, not sure if related. Thanks again Mike |
Author: | tjc [ Sat May 26, 2007 7:44 pm ] |
Post subject: | |
BTW - I suspect Cecil won't think this belongs under installation... ![]() |
Author: | mjl [ Sat May 26, 2007 8:03 pm ] |
Post subject: | |
Hi, You are most likely correct as it is "post installation" but did seem appropriate at the time. Humble appologies ![]() Mike |
Author: | tjc [ Sat May 26, 2007 8:06 pm ] |
Post subject: | |
Pick another spot and I'll post my xine configs to see if they do you any good. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |