LinHES Forums
http://forums.linhes.org/

Getting remote working again under R6
http://forums.linhes.org/viewtopic.php?f=6&t=20633
Page 2 of 2

Author:  christ [ Sat Jan 30, 2010 6:50 pm ]
Post subject: 

ah ok. I am surprised that driver outputs codes at that level but given yours works then it would seem to be ok.

Author:  mihanson [ Sun Jan 31, 2010 9:54 am ]
Post subject: 

Greg Frost wrote:
mihanson: what is the command line for lircd?


It's lircd1 because when I boot up my lircd starts my working serial ir receiver. I stop lircd, rmmod lirc_serial and restart lircd by hand using the same command you have, but lirc1 instead of lirc0 for the GP-IR02BK.

Author:  marc.aronson [ Tue Oct 11, 2011 1:11 am ]
Post subject: 

I am attempting to get a GP-IR02BK remote working, without success. I've started a new thread for this issue, located here. I'm posting a cross-reference here as I am hoping that someone on this thread can help me figure this out. Thanks!

Page 2 of 2 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/