When I power up the system, I notice that both the VGA and TV-Out are detected as connected and used properly. During the installation of KnoppMyth (both text and graphical) I also notice that both are enabled. Once in the graphical installation, I also noticed that X is working fine on both montiors.

However, after install the nVidia drivers and changing the XF86Config-4, I notice that I can only seem to get one or the other working and not both. (Now, I'm sure with more digging I can probably figure out how to do it. Probably have to setup TwinView in Clone mode or something.)

But it just occurred to me, well, the graphical portion of the install works just fine -- what XF86Config are they using for that and how can I get it so I can use it instead, as I would prefer to have both the monitor and TV working.