Has anyone tried to install R5A10 and a AverTV DVB-T 771 card yet ?. Looks like the card is detected but mythtv-setup says i card find the card dvb0... any help appreciated.

Is ther surposed to be a frontend0 interface like in R4V4 ?

dmesg:

bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 18 (level, low) -> IRQ 18
bttv0: Bt878 (rev 17) at 0000:00:0a.0, irq: 18, latency: 32, mmio: 0xcdcfe000
bttv0: detected: AVermedia DVB-T 771 [card=123], PCI subsystem ID is 1461:0771
bttv0: using: AVerMedia AVerTV DVB-T 771 [card=123,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00f0ff0f [init]
bttv0: using tuner=4
tuner: Ignoring new-style parameters in presence of obsolete ones
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "dvb0"

No firmware for DVB cards are included. If your cards requires firmware, that is the issue.

_________________
cesman

When the source is open, the possibilities are endless!

Is ther a howto on installing firmware into myth for DVB-T cards ?

Thankx in advance

Those boot messages are mostly from BTTV, which is the Video4Linux driver. It would be for digitizing analogue video if that card has an S-Video or Composite video signal. It doesn't do much with DVB cards.

Yes, there is meant to be a frontend device. I think the 771 needs the mt352 frontend, which isn't in 2.6.9 or R5A10.

A quick web search found:
http://www.dtvforum.info/lofiversion/in ... 14268.html

which implies that
1) the Aver 771 doesn't need downloaded firmware, and
2) the kernel in R5A10, which I think is 2.6.9, doesn't include the drivers for this DVB card. 2.6.10 will probably work fine.

Note that Aver has a Linux howto page:
http://www.aversupport.co.uk/support/DV ... 0Linux.pdf

_________________
| Nigel Pearson, nigel.pearson.au@gmail.com
| "Things you own end up owning you" - Tyler, Fight Club